Hydraulic cone crusher equipment is an effective crushing equipment, widely used in mining, construction and other industries. It uses a hydraulic system to adjust the discharge port and overload protection, and has the characteristics of large crushing ratio, high efficiency and stable operation. Hydraulic cone crusher is suitable for medium and fine crushing of medium-hard and hard materials. The discharge particle size can be controlled by adjusting the discharge port size to ensure the uniformity and quality of the product.

How to Install Hydrualic Cone Crusher Correctly?

Foundation preparation. Select a stable foundation surface to ensure that the ground is flat and has sufficient bearing capacity. Carry out foundation construction according to the foundation drawing provided by the equipment supplier to ensure that the foundation size and strength meet the requirements.

Equipment in place. Use a crane or forklift to place the hydraulic cone crusher equipment on the prepared foundation. Use a level to check the levelness of the equipment and adjust the shims if necessary to ensure that the equipment is in a horizontal state.

Connect the hydraulic system. Connect the hydraulic pipeline between the hydraulic pump station and the crusher to ensure that the connection is firm and leak-free. Check the oil level in the hydraulic oil tank and add hydraulic oil to the appropriate position as required.

Electrical connection. Connect the power cord according to the electrical wiring diagram to ensure that the electrical connection is correct. The grounding wire must be reliably grounded to prevent leakage accidents.

Install auxiliary equipment. If equipped with auxiliary equipment such as feeders and conveyor belts, they must be installed according to the corresponding installation drawings. Ensure that the connection between the auxiliary equipment and the hydraulic cone crusher is accurate.

Pre-commissioning inspection. Before starting the hydraulic cone crusher equipment, check to confirm that all components are tightly connected and there is no looseness. Check the lubrication system to ensure that the lubrication points are fully lubricated. Check whether all safety protection devices are intact and in the open state.

Test run. After completing all the above steps, perform a no-load test run to observe whether the equipment has abnormal vibration or noise. Gradually load the test run and observe the operating status of the equipment until it reaches full load operation.

The correct installation of the hydraulic cone crusher can ensure its efficient and stable operation. During the installation process, be sure to operate according to the equipment manual and the guidelines provided by our company to ensure that all components are firmly installed and the hydraulic and electrical systems are working properly. If you have any questions, it is recommended to contact professional technicians in time for inspection and debugging.

We hope this blog can help you install the hydraulic cone crusher smoothly! If you have any other questions, please feel free to contact me.